So we built a d-ring to mount onto almost any backplate! How you ask? Well we made one of the holes fixed so your d-ring stays located in the same area and then we made a 2 1/4" long slot so no matter where you mount it and on any of the different made backplates you can secure the bottom hardware by sliding it to match up with another hole in your backplate!!
We also made this d-ring just a little larger then normal to make sure you can find it with ease on the side of your plate! Ir reaces out 1 5/8" inches measuring the inside of the D
We also supply all the needed 3/8"-16 stainless steel hardware and use a nylon insert lock nut to hold it tightly to your plate. Our kit includes:
1 Backplate D-Ring ** 304 marine grade stainless
2 7/32 Hex Head button cap screw **316SS
* You need a 7/32 Allen Head Tool for this bolt
2 Nylon insert lock nut **316SS
4 Washers **316SS
Overall Measurements:
3 1/2" inches long
2 5/8" inches wide
1/4" thick
1 5/8" inside D measurement
Slot Measurement: Middle of fixed hole to shortest to furtherest slot length: 15/16" to 3" inches
Your backplate D-Ring has been tumbed for at least 48 hours giving it a smooth finish with no sarpe edges
If you want your D-ring slightly bent select from our drop down box below and make sure to read to know how the bend will be facing
* Example: If you select the fixed hole on the top and you want your D-ring slightly bent forward it means your bend is slightly in front of your backplate hardware and if bent backwards it would mean your bend is slightly behind where you mount it...
 "Backplate D-Ring w/ Adjustable Mounting Slot \"Per Piece\"")
