Our hoses are made from the highest quality materials available
Our High Pressure hoses have a 7/16 fitting and will fit most of today's first stages
Working pressure of 4500 - 6,600 psi ensures against hose failures
Burst pressure rating of 30,000 psi gives you that extra safety margin
Great HP hose for your single pressure gauge or stage/pony gauge
NOTE: This short hose was made to stop your transmitters from being grabbed and damage by boat personnel who sometimes use your transmitter as a handle!
LASTLY make sure you either have a high pressure spool to go into the bottom of your transmitter or select one from our drop down box below! Otherwise your hose will leak around the swivel area of your hose!!
Made with a kevlar internal liner to give a better overall strength
Has a strain relief by the male thread end of the hose
CE EN250 Certified hose
Comes with a viton o-ring so you can use for air or mix gases!
Cleaned and ready for nitrox mixes up to 40% or mix gases!
Black Only
WARNING: You need to make sure you are using a high pressure spool that fits between the hose and your gauge otherwise you may have air leaks and without it reducing the high pressure air it could damage the gauge / transmitter!! You can find the High Pressure spool in our drop down box or in our gauge section of our website.. We recommend the P2 spool Type
Don't forget to check out our SPG's located in our gauge section! When purchasing both an hp hose and Spg you can save a few $$$ as a combination purchase. We carry both 2 & 2.5 inch size Spg's with glass faces
NOTICE: Our New Rubber Kevlar hoses DO NOT USE the polyester-TPU lining that is causing internal issues with some hoses low pressure and some high pressure hoses that could be on the market today!
